Korena by Guitar Center
Product detailSKU #1430749400146

CrownXLS1502 2-Channel 525W Power Amplifier With Onboard DSP

Crown
Crown XLS1502 2-Channel 525W Power Amplifier With Onboard DSP
1/8

Independent shopping perspective

The Korena take

Crown’s XLS1502 is a two-channel power amp for PA systems that need configurable output without adding much weight to the rack. Its onboard DSP lets you set levels, EQ, delay, and crossover points from the amplifier, while the LCD keeps operating settings and status in view. It can run 2-, 4-, or 8-ohm loads in stereo, or operate bridged mono. At 8.6 lb., it is straightforward to carry between rehearsal, stage, and mobile-production setups.

Crown XLS1502 2-Channel 525W Power Amplifier With Onboard DSP product detail
Product studyCrown XLS1502 2-Channel 525W Power Amplifier With Onboard DSP
Crown XLS1502 2-Channel 525W Power Amplifier With Onboard DSP alternate view
Alternate view

Strong match

Who this is for

  • Portable PA racks where low amplifier weight matters during transport and setup.
  • Speaker systems needing stereo operation across 2-, 4-, or 8-ohm loads.
  • Sound systems that need onboard EQ, delay, level, and crossover adjustment.

What matters in use

The specifications, translated

Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.

Crown XLS1502 2-Channel 525W Power Amplifier With Onboard DSP construction detail

Detail 01

525W per channel at 4 ohms

Provides the stated dual-channel output for a 4-ohm speaker load.

Detail 02

1,550W at 4 ohms bridged

Allows the two channels to be configured as one bridged-mono amplifier.

Detail 03

8.6 lb.

Keeps rack transport and placement less cumbersome.

Detail 04

19 x 3.5 x 7.7 inches

Fits a 19-inch rack width with a 3.5-inch height.

Final check

Know before you order

  1. 01Confirm whether your system needs stereo operation or bridged mono, and match the connected load impedance accordingly.
Crown XLS1502 2-Channel 525W Power Amplifier With Onboard DSP close-up

Product questions

Before you decide

Straight answers to the questions shoppers most often ask about this product.

01Can the XLS1502 run in bridged mono?

Yes. It supports bridged-mono operation and is rated at 1,550W into 4 ohms bridged.

02What can I adjust with the onboard DSP?

The DSP provides adjustment of levels, EQ, delay, and crossover points.

Reference

Full specifications

The complete catalog record, organized around the decisions musicians make when comparing gear.

18 detailsOther
Category Source
detail
2 ohm Dual
775W
Signal to Noise
> 97dB (at .775Vrms sensitivity, 6dB lower)
Crosstalk
At 1kHz: > 85dB, At 20kHz: > 55dB
8 ohm Bridged
1,050W
Dimensions
19" (48.3 cm) x 3.5" (8.9 cm) x 7.7" (19.6 cm)
Korena Special
false
Damping Factor
> 200
Weight
8.6 lb. (3.9 kg)
THD
< 0.5%
Sensitivity
1.4Vrms
4 ohm Dual
525W
Intermodulation Distortion
< 0.3%
Tier
new
4 ohm Bridged
1,550W
Source Id
site51430749400146
8 ohm Dual
300W
Frequency Response
+0dB, -1dB

Worth comparing

More from Crown