Detail 01
8mm thread
Matches Yamaha's standard 8mm hardware. Check your existing bolt first; 6mm is close enough to confuse at a glance.

Independent shopping perspective
A short 8mm wing bolt for Yamaha drum hardware. Buy it to replace a missing or stripped bolt on a clamp, holder, or memory lock.


Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.

Detail 01
Matches Yamaha's standard 8mm hardware. Check your existing bolt first; 6mm is close enough to confuse at a glance.
Detail 02
Sized for shallow clamps and holders. On a thicker clamp body it may not bite deep enough to hold.
Detail 03
Hand-tightens with no drum key. Faster setup, and it stays usable when your key is missing.
Detail 04
Cut to Yamaha thread spec. Other 8mm hardware often accepts it, though cross-brand fit is not guaranteed.
Final check

Product questions
Straight answers to the questions shoppers most often ask about this product.
It is Yamaha's short version of the 8mm wing bolt, meant for shallow clamps and holders. Compare it against the bolt you are replacing before ordering.
A bolt is the threaded shaft with a wing head; a nut threads onto an existing rod. Which one you need depends on the hardware.
It is cut to Yamaha's 8mm spec. Other brands using 8mm often accept it, but thread pitch and fit vary across brands, so check before relying on it.
No. The wing head tightens by hand, which is why it is used where you set up and tear down often.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.